Belt-drives TF-2000 Manual de usuario descargar pdf

INSTALLATION FOR TOP FUEL 14MM DRIVE

Kit numbers TF-1000, TF-2000

Refer to Warranty, Introduction, belt tracking and starter gear problems, alignment procedure and 3" Electric

Start Installation for FXR and Softail for general instructions.

1. Install oil line fittings on back side of motor plate, cut hose to make 2 pieces, top fitting is for oil return ( oil out

of filter), bottom fitting is for oil feed ( oil into filter).

2. Install motor plate with alternator cover over engine spacer and install

the 2 standoffs. Be sure that the motor plate is aligned properly.

Fig. 1

Fig. 2

Fig. 3

3. Install threaded oil filter mount on front side of motor plate, grease

rubber gasket on oil filter and install hand tight. (Fig. 4 & 5) Install starter

pinion gear supplied with kit. (See PG-100 Installation).

Fig. 4

1 2 3 4 5

Indice de contenidos

Pagina 1 - Install starter

INSTALLATION FOR TOP FUEL 14MM DRIVEKit numbers TF-1000, TF-2000Refer to Warranty, Introduction, belt tracking and starter gear problems, alignment pr

Pagina 2 - Fig. 5 Fig. 6

Fig. 5 Fig. 64. The pictures below refer to special bushing enclosed which is used only to install front pulley, it is a tool only and must be removed

Pagina 3

Fig. 108. Install engine shaft nut and torque to Harley specifications. An electric impact may be used.(Fig. 11 & 12)Fig. 11Fig. 129. Install clut

Pagina 4

FIg. 14Fig. 1511. Install starter housing. Be sure starter is aligned properly then bolt down securely. (Fig. 16)Fig. 1612. Install front pulley cover

Pagina 5

14. Install clutch adjustment screw and adjust clutch as necessary. Refer to 3" Electric Start Installation for FXR. Install nut and tighten afte