Belt-drives EVO-10STF Manual de usuario
Busca en linea o descarga Manual de usuario para Para Motocicletas Belt-drives EVO-10STF. Belt Drives EVO-10STF User Manual Manual de usuario
- Pagina / 3
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
INSTALLATION FOR 3” ELECTRIC START FOR 1970-78 SHOVELHEAD
(Kit numbers EVO-10S, EVO-10ST, EVO-10SF, EVO-10STF)
KICK START:
(Kit numbers EVO-4S, EVO-4T, EVO-5S, EVO-5T,
EV-76-47S, EV-76-47T, EV-72-47)
NOTE: THIS DRIVE REQUIRES A STOCK 1991 UP STARTER. THIS KIT WAS DESIGNED AROUND A STOCK FX.
AFTER MARKET STARTERS WILL NOT FIT WITH A STOCK OIL TANK AND BATTERY BOX. A 1979 CLUTCH
RELEASE ARM WILL ALSO BE NEEDED, OEM # 37054-79, AND THIS ARM WILL NEED SLIGHT
MODIFICATIONS TO WORK. SEE INSTRUCTIONS BELOW.
Be sure to read the Warranty, Introduction, belt tracking and starter gear problems, alignment procedure and
disconnect battery.
1. Remove outer primary cover, chain or belt drive and inner primary.
2. Loosen transmission completely.
3. Modify stock oil tank support bracket by notching
it as illustrated at right. This will allow clearance to the
back side of the starter. (Fig. 1)
4. BE SURE BATTERY IS DISCONNECTED.
5. Install starter pinion gear, supplied with kit, onto
6. Install cables on to starter and place starter on
transmission for later installation.
7. The clutch release arm must be clearanced to
achieve maximum travel of the arm against the
starter. (Fig. 2)
Fig. 1 Fig. 2
Cut a notch in oil tank support bracket as pictured above
for clearance on the back side of the starter.
Grind side of arm to allow maximum travel against starter when
installed.
1
starter shaft. Apply red Loctite® and install starter bolt.
Indice de contenidos
Pagina 1
INSTALLATION FOR 3” ELECTRIC START FOR 1970-78 SHOVELHEAD(Kit numbers EVO-10S, EVO-10ST, EVO-10SF, EVO-10STF) KICK START:(Kit numbers EVO-4S, EVO-4T,
Pagina 2
8. Install motor plate and tighten bolts to motor and transmission. Check clearances between transmission plate and frame, (shim if necessary, plug fi
Pagina 3 - Loctite® to a bolt and
12. Install Quiet Clutch, 1-.120" (EDP-200) spline steel first, then alternate fiber and steel ending with a steel.Install pressure plate, spring
Relacionado con productos y manuales para Para Motocicletas Belt-drives EVO-10STF
(1 paginas)Silverline Jump Starter & Air Compressor Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Elektrowerkzeuge Silverline Jump Starter & Air Compressor.
Wir stellen 1 PDF-Handbücher Silverline Jump Starter & Air Compressor zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentarios a estos manuales